yeep.me eSIXTEEN Originalhandbuch Seite 18

• Avoid recharging the battery right after use. Allow the device to rest for between
EN
15 minutes and 1 hour after use before charging.
• Avoid overcharging. Do not leave the charger plugged in for more than 24 hours, as
it will heat up needlessly.
Notice: We recommend recharging the battery, if not in use, after each use and at
least once a month.
Important: If you are not near a charging point when the battery is down to its last
quarter, we recommend switching to eco mode.
Tip: As you drive, the battery level indicator on the display may suddenly decrease
depending on your driving style and conditions (heavy use of the accelerator, riding
uphill, outside temperature below 10°C, etc.). Be aware that the actual battery level
displayed will be most accurate when the device is turned off.
4.2. INSPECTING AND MAINTAINING YOUR DEVICE
Your product requires routine inspection and maintenance.
This chapter describes maintenance and operation steps.
Before performing the following operations, make sure that the power is off and that
the charging cable is unplugged.
MAINTENANCE AND SPARE PARTS:
Your device requires regular maintenance for your safety but also to increase its life
span. Mechanical components should be checked periodically to ensure that worn or
worn-out parts are replaced if necessary.
CAUTION: When replacing components, original parts must be used in order to
maintain the performance and reliability of the device. Only the manufacturer's parts
are considered original.
CAUTION: The user is solely responsible for the purchase and use of counterfeit parts,
which may result in damage to the product, the user or the environment.
Make sure to use appropriate spare parts for the wheels, drivetrain components and
the various components of the braking system. If you have any questions, please
contact the after-sales service.
The manufacturer cannot be held responsible for improper use or incorrect assembly.
Before each use, carefully check:
• That the handles are fully tightened.
• That the wheels are functioning properly by lifting the device and running the
wheels idle.
• The column, the steering tube, nothing must prevent it from turning. The entire
steering system must be correctly adjusted and all connecting elements and screws
tightened and in good condition.
• Check the tightness of the screws, the front and rear wheels, shock absorbers, and
bonnet, and tighten again if necessary. These adjustments may be needed because of
vibrations caused by using the device.
18