Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FRONT PANEL FACILITIES
@ POWER SWITCH (POWER (©))
@ POWER INDICATOR
© PHONES JACK
Use this jack for listening to the program source through your head-
phones. Connect the plug on the headphones properly to this jack.
Once connected, no sound will be heard through the speakers.
NOTE:
Get into the habit of turning down the volume before plugging in
the headphones. Loud sounds can damage your ears.
@ BASS CONTROL
This is used to adjust the bass (low-frequency) sound.
CONNECTION
DIAGRAM
@
TREBLE CONTROL
This is used to adjust the treble (high-frequency) sound.
@
BALANCE CONTROL
This control should normally be set to the center position, when the
output from the left and right speakers or headphones is not the
same, adjust by turning the control clockwise or counterclockwise.
@
TAPE/MONITOR SWITCH (MONITOR)
Set this switch to ON when using a tape deck or a graphic equalizer
(or any equipment) connected to the TAPE/MONITOR
terminals.
@
FUNCTION SWITCH
This is used to select the program source which is to be heard.
PHONO:
For playing records on the turntable connected
to the
PHONO terminals.
TUNER:
For listening to broadcasts on a tuner connected to the
TUNER terminals.
@
VOLUME CONTROL
This is used to adjust the volume of the speakers and headphones.
@
INDICATORS
(FUNCTION
and MONITOR)
The
indicator corresponding
to the selected
function
switch
or
TAPE/MONITOR
switch lights.
Speaker system
TROUBLESHOOTING
Left
(To TAPE terminals)
AC wall socket
(AC 220 Volts~)
Right
If you think that something has gone wrong with your unit, check out the points below before calling in the serviceman. The cause of the trouble may lie in improper
maintenance or operation. If the trouble is still not remedied even after the checks have been carried out, contact an authorized PIONEER service station.
Cause
Symptom
© Power switch OFF.
® Disconnected power cord.
e VOLUME
control at minimum.
© Headphones plug connected.
- No sound even when FUNC-
TION switch is set.
you want to listen to.
No sound from one speaker
tion.
Disconnected speaker cord
¢ VOLUME control is set too high.
¢ BASS control is turned too high.
Sound is distorted
¢ The TAPE/MONITOR switch is in the ON position.
e The FUNCTION
switch is not set to the program source
© Set to ON.
e Re-connect properly
e Rotate VOLUME
control to the right.
e Disconnect.
e Set the TAPE/MONITOR
switch to the OFF position.
e Set so that the selector corresponds to the program
source.
e BALANCE
control turned too far to the left or right posi-|
* Set control to center position
Re-connect properly
e Rotate VOLUME
control to left.
© Rotate towards "0".
Werbung
