Beper P102FRU100 Bedienungsanleitung Seite 7

EN
Hand blender Use instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Some warning
The product is designed to run continuously for a maximum of 1 mi-
nute, then leave it rest for a further minute, otherwise it may cause
overheating and the product will stop working.
Always disconnect the plug from the power outlet when connecting
and disconnecting the blades unit to the main unit.
Always make sure that the blades are well connected to the main unit
before operating.
Do not work foods too hot.
Do not work a quantity of food more than three quarters of the length
of the blades unit.
Description of the product Fig.A
1. Speed control knob
2. Slow and adjustable speed button (on/off)
3. Turbo speed button (turbo)
4. Main unit
5. Detachable blades unit
Operation
Remove the product from the packaging and check that it is intact and that all components are inside.
Carefully wash the product, as described in the appropriate "cleaning" section.
Connect the blades unit to the main unit, paying attention to aligning the triangle symbol marked on the blades
unit with the padlock open marked on the main unit and turning in the direction of the padlock close. Proceed in
the reverse direction to detach the blades unit.
Insert the plug in the socket, making sure that the wire is not dimmed and / or close to heat sources.
Insert the blades unit into the container with the food previously cut and which is recommended to have added
liquid (water, milk, broth). Do not operate the appliance with solid foods only.
Use a container large enough so that no sketches come out.
Activate the product by pressing the desired button.
Turbo button = the product will start working at maximum speed. You will not be able to adjust the speed with the
knob placed over the main unit.
Slow & Adjustable Speed Button = The product will start working at a slower speed that you can adjust with the
knob placed on the top of the main unit.
7