Cleaning And Maintenance - UNIPRODO UNI TRAMPOLINE 01 Bedienungsanleitung

15) Place the narrower end of the tube in the wider end
of the second tube so that the bolt holes overlap.
Secure the connection with the bolt and nut.
NOTE! The factory-installed protective foam can make
it difficult to find the right ends.
16) Repeat step 15 to assemble all the posts.
17) Insert the narrower end of the post into the hole
in the circular frame so that the bolt holes overlap.
Tighten the bolts in the threads.
18) Repeat step 17 to assemble all the posts.
19) Find the six nylon grommets sewn to the upper edge
of the upper security net. Choose a nylon patch
coinciding with the post.
20) Put the patch onto the post so that the grommet
coincides with the bolt hole of the post. Insert the bolt
and tighten. Repeat this operation on each post.
NOTE! Be careful not to break the upper protective
net.
21) Locate the velcro on the outside of the top protective
mesh, then cover the post with velcro and fasten it.
There are two velcros for each bar.

3.3. CLEANING AND MAINTENANCE

a) Use only non-corrosive cleaners to clean the surface.
b) Store the unit in a dry, cool place, free from moisture
and direct exposure to sunlight.
c) The device must be regularly inspected to check its
technical efficiency and spot any damage.
d) Use a soft cloth for cleaning.
e) It is recommended to use a protective tarpaulin when
the trampoline is not in use in order to protect it
against the harmful effects of weather
EN 8