AEG 11125 Bedienungsanleitung Seite 29

CLEANING, CARE AND
MAINTENANCE
Caution!
Power off the monitor and unplug the vehicle's 12 V
power supply before cleaning the monitor.
•
Clean the reversing camera system with a dry
cloth. Do not use liquids or harsh cleaners as
these may cause discoloration and damage to the
surface of the equipment and the backup camera
system may be damaged! Do not allow liquids to
enter the equipment! Never immerse the equip-
ment in liquids! Only operate the backup camera
system when dry.
•
Always keep / store the backup camera system
in a dry environment! Moisture may damage the
electronics of the backup camera system!
•
Do not store the backup camera system under
extreme temperature fluctuations! Condensation
generated under these conditions could damage
the electronics!
•
If the camera joint loosens over time you may
readjust it. There are 4 screws at the back of the
camera inside the camera bracket. Slightly tighten
these screws to secure the swiveling camera. This
requires the camera to be dismantled.
Replacing fuses
A fuse inside the car plug safeguards the device.
This will respond in the event of a short circuit or
voltage peaks and must then be replaced.
Attention:
Do not use higher rated fuses. The electronics may
otherwise be damaged.
3
2
1
1. Unscrew the retaining pin (1) with the fuse cover
(2) from the car plug (4).
2. Insert a new micro-fuse (3) of the same rating
(see Technical Data).
3. Replace the retaining pin (1) with the fuse cover
(2) in the car plug (4).
Service
Should you have any questions regarding com-
missioning or operating in spite of studying these
operating instructions, or if a problem should occur
against all expectations, please get in contact with
your specialist supplier.
Disposal
The packaging consists of non-contaminating mate-
rials that you can dispose of at your local recycling
point.
In accordance with European Directive 2012/19/
EC for waste electrical and electronic equipment
(WEEE) and conversion to national law, used electri-
cal appliances must be collected separately and
taken to a recycling point. For ways to dispose of old
electrical appliances please contact your community
or city administration.
EU Declaration of Conformity
MTS MarkenTechnikService Gmbh & Co. KG
hereby declares the wireless system model "Mirror
Reversing Camera" (11125) complies with Directive
2014/53/EU.
For the full text of the EU declaration of conformity
please visit:
http://iuqr.de/11125
Images and actual product may vary slightly.
Subject to change for the purpose of technical
advances. Accessories not included.
4
Do not throw electrical appliances in with
domestic waste!
English 29