AEG 11125 Bedienungsanleitung Seite 26

26 www.aeg-automotive.com
Place the red transmitter cable sideways into the
clamp connector (9) (see image 9).
Image 9
Using a pair of pliers (not included) push the pro-
truding metal contact into the cable clamp (9). This
will connect the two cables.
Image 10
Close the cable clamp (9) fuse cover.
Image 11
Using the second cable clamp (9) connect the
vehicle's 12 V - (negative) reversing light cable with
the black transmitter cable as shown in images
8 - 11. Then reconnect the negative cable to the
vehicle's battery.
Attention:
If you are unfamiliar with the installation and the
connections or are unsure with one of these steps,
please consult a specialist regarding the installa-
tion! There is a risk of property damage or personal
injuries!
Step 8: Installing the transmitter
Secure the transmitter with a suitable fastener, e.g.
two cable ties. Be sure there are no electrical loads
in the direct vicinity of the transmitter to avoid
impairing the transmission. Now secure the cables
for the camera and transmitter run in the void of
the trunk with cable ties (6). The cables run may not
interfere with the vehicle's functionality!
Step 9: Check the transmitter power supply cable
First engage the hand brake and be sure the vehicle
is not shifted into gear. Vehicles with automatic
transmission must be in "P" for parking lock. Turn
the ignition to II but do not start the engine! Push
the button (14) to power on the monitor. If the
transmitter is correctly connected, a signal will now
be transmitted to the monitor when putting the
car into reverse and the monitor will display the
camera's viewing range.
If no image is displayed on the monitor, you can
further check the camera power supply with the
hand brake engaged, ignition turned (II) and the
vehicle in reverse with a simple test. Do not start
the engine! Completely cover the camera with both
palms cupped to darken the camera surroundings
and activate the night vision sensor. Leave a slight
opening between your thumbs and look into your
palms. If the camera is active, all 7 LEDs around the
camera will light up red. If the LEDs do not light up,
check the camera's cable and terminal connections.
Also see "Troubleshooting".
Installing the monitor
Position the monitor (3) on the rear view mirror (see
image 12). Attach the retaining straps (12) to the top
retaining hook of the monitor (3). Pull the straps
around the back of the rear view mirror and secure
the straps to the bottom of the retaining hook.
Attention!
The monitor must be firmly secured to the rear view
mirror in the vehicle using the strap and must not
be loose or wiggle. Check before every trip. Do not
use the monitor if it is not secure.
Image 12