Frigomat MIX8 Gebrauchsanweisung Und Wartungshandbuch Seite 56

8.2 HEATER TROUBLESHOOTING
PROBLEM
The machine does not start
(STOP button off).
After the extraction there is
still too much product in the
vessel
The machine works regularly
but the heating times are
long.
During functioning the
machine becomes noisy and
the beater stops.
The machine becomes noisy
during operation.
The machine does not heat
within normal time and a loss
of blue fluid is detected
under the machine.
27 - ENGLISH
PROBABLE CAUSES
Master switch open.
Electrical anomaly.
Fuses blown.
Insufficient rear feet adjustment.
Product insufficient.
Open lid.
Faulty resistance or fluid pump.
The belt slips.
Transmission shaft without
lubrication.
Loss of glycol from the system.
REMEDIES
Close the switch.
Contact the technician.
Contact the technician.
Adjust the rear feet so that the
product contained in the vessel
comes out.
Work with at least 1/2 the
maximum amount of product
allowed.
Make sure that the lid is
assembled and closed properly.
Contact the technician.
Contact the technician to check
the belts tension and possibly
replace it.
Remove the mixer and pull the
transmission shaft upwards.
Verify and lubricate with food
grease.
Contact the technician.