Zanussi ZBF22451SA Benutzerinformation Seite 22

Problem
The compressor does not start
immediately after pressing the
"QuickFreeze", or after chang-
ing the temperature.
Temperature cannot be set.
dEMo appears on the display.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
TECHNICAL DATA
PRODUCT INFORMATION SHEET
Trade Mark
22
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The "QuickFreeze function"
is switched on.
This is normal, no error has
occurred.
The "QuickFreeze function"
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The door has been opened
often.
The "QuickFreeze function"
is switched on.
There is no cold air circula-
tion in the appliance.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "QuickFreeze function".
The compressor starts after a pe-
riod of time.
Switch off "QuickFreeze func-
tion" manually, or wait until the
function resets automatically to
set the temperature. Refer to
"QuickFreeze function".
Keep the OK pressed for approx-
imately 10 seconds until a long
sound is heard and display shuts
off for a short time.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Open the door only if necessary.
Refer to "QuickFreeze function".
Make sure that there is cold air
circulation in the appliance.
Zanussi