AquaMedic AT-Control Schnellanleitung Seite 8

Choose "calibrate sensor" in the pH menu. Place the pH probe into the test fluid pH 7,0. Adjust the
calibration value on the screen to 7,0 and wait until the shown" read value" is stable. This may
take a few minutes. Press now the "Enter" key to calibrate the sensor at pH 7.00. The screen for
the steepness opens. Here, the electrode is calibrated at pH 4.00. Take the probe out of the
pH7.00 fluid, rinse it carefully with distilled water and dry it. Now, place it into the test fluid pH
4.00. After 5 – 7 minutes, when the reading remains constant, press "Enter" to calibrate the
electrode at pH 4.00.
Don't forget to switch on the solenoid valves again.
Level Program
In the first line, the type of control can be programmed:
„Off" The level sensor is switched off.
„LIV 1" Minimum program. If the water level is lower than the sensor, the programmed plug
will be activated. This is the position for a top up program. If the level decreases, the pump is
switched on.
„LIV 2" Maximum program. If the water level is higher than the level sensor, the plug is
activated. This is the program for the dry running protection of a pump (if the level sinks the pump
will stop.)
_______
Level_________
Off
Max Time Off
PU01 1
In the lower line, the desired plug can be programmed with the arrow keys. The programming is
correct when the level icon appears above the plug and the plug is marked.
This Quick Guide will not replace the complete instruction manual. It is only a help for the quick
installation of the AT-Control.
AB Aqua Medic GmbH
Gewerbepark 24
49143 Bissendorf/Germany
info@aqua-medic.de
2 3 4 5 6
By pressing the arrow keys→ ←, the position
"Max Time OFF" can be addressed. Here, the
On-Time can be limited. If, e. g. the re-fill pump
in a certain time (max. time) did not reach the
level LIV1, the plug is blocked and has to be
manually deblocked. This is a security program.
In the "Off"-mode, it is deactivated.
08/2012
8