Hellberg Synergy Multi-Point Gebrauchsanweisung Seite 8

ear. Remember to adjust the volume when working in noisy environments so that any warning signals etc. can
be heard.
On/Off Volume Radio
Turn the dial (A:10) to switch on the radio. Continue turning clockwise to increase the volume.
In the event of poor reception conditions, the radio automatically switches from stereo to mono mode to
maintain optimal audio quality.
Frequency/channel selector
Turn the dial (A:11) to choose radio stations. The radio's frequency range is FM 88-108 MHz, AM 540-1700
KHz (A:11b).
Level Dependent "Active listening"
The hearing protector is equipped with Level Dependent "Active listening". If interference or faults occur,
consult the manufacturer's instructions on maintenance and battery replacement.
Warning! The sound from the Level Dependent "Active listening" on the hearing protector can exceed the
external noise level.
On/Off Volume Level Dependent function
Turn the dial (A:12) to turn on the active listening microphones. Continue to turn clockwise to increase the
volume. Check that the function is operable before using the unit in a noisy environment.
Level Dependent + Radio (A:12, A:10)
Both functions have individual volume control. Adjust the volume to the desired level.
External audio input (A:13)
The hearing protector is equipped with an electronic audio input. You can connect a com-radio or other
external audio source to the 3.5 mm audio input via the included connection cable (B:6). Check that the
function is operable before using the unit. If interference or faults occur, consult the manufacturer.
Warning! Connection of an external audio source can entail a sound level that exceeds the daily permitted
exposure level.
NOTE! The volume function (A:12 or A:10) must be turned on when using the external audio input.
USER INSTRUCTIONS FOR BLUETOOTH® FUNCTIONS
You also need access to the user instruction for the Bluetooth® compatible unit (mobile phone etc.)
communicating with the headset. The hearing protector features level-limiting of audio signals from the
speakers to maximum 82 dB(A) at the ear.
Pairing with other Bluetooth® unit
Pairing establishes a wireless link for communication between the units. Pairing is only needed once for each
pair of units. The headsets can store up to 8 different units in its memory.
1. Start the headset Bluetooth® function by pressing and holding down the Bluetooth® knob (A:14) (from
here on referred to as the BT knob) for 3 seconds. An audio signal with 4 ascending tones is heard in the
headset. The headset LED light (A:15) flashes red/blue to confirm pairing mode. Release the BT knob.
2. Start the Bluetooth® function on your phone (or other unit) and search for and connect to new unit. See the
user instruction for your phone (or other unit). HELLBERG SYNERGY is shown in the phone's display. If the
phone requires a PIN code, enter four zeros (0000).
3. An audio signal with 1 tone is heard in the headset when the link is established and ready for
communication. The headset LED flashes blue.
4. If the pairing fails, switch off all headset functions and restart again from step 1.
Pairing with a second Bluetooth® unit (only SYNERGY Multi-Point models)
If your headset model supports Multi-Point technology you can connect 2 units to the headset at the same
time.
1. Re-enter pairing mode by pressing and holding down the BT knob for 3 seconds. An audio signal confirms
pairing mode and the first paired unit is temporarily disconnected during paring with the second unit.
2. Start the Bluetooth® function on your second unit and search for and connect to HELLBERG SYNERGY
MP. An audio signal confirm unit 2 is connected.
3. Re-connect unit 1 by selecting HELLBERG SYNERGY MP in the display of unit 1. An audio signal confirm
unit 1 is connected.
8
Synergy Synergy