REV Ritter LED GIGA SENSOR Bedienungsanleitung Seite 9

GB
LED Giga Sensor
Assembly and operating instructions
INTRODUCTION
Dear Customer,
We'd like to thank you for purchasing our product. Please read the following operating instructions thoroughly
before using this product for the first time and keep it handy for future reference (S1).
Please check the product before use for any damage.
PROPER USE
• Luminaire for wall and ceiling mounting on normally flammable surfaces in dry spaces.
• Not suitable for through-wiring.
• The product conforms to the appropriate European CE directives (S2).
• This product conforms to the appropriate European safety standards.
• The product is IP20 rated and suitable for use in dry interior spaces (S3).
• The product is intended exclusively for household use or similar purposes. It must not be used for commercial
purposes!
• The product may only be used only for the purpose for which it is intended, in accordance with this user manual!
• The product is not suitable for rough use (e.g. construction sites)!
• The product is not intended for use by persons (including children) whose physical, sensory or mental abilities
are limited or who lack experience and knowledge! These persons may only use the product if they are
supervised by a person responsible for their safety, or if they have been inducted into how to use the product!
The supervision and use of this product must be carried out by a responsible person!
GENERAL INFORMATION
• Disconnect the product's mains power plug in the event of a fault during operation.
• Only use the supplied original parts!
• Do not use additional components!
• This product has no replaceable parts. Do not attempt to open or repair this product!
GENERAL SAFETY INSTRUCTIONS
• Please observe the technical specifications!
• Please follow this instruction manual and keep it in a safe place!
• Please pass on this instruction manual to a subsequent owner!
• Not to be used by children!
• Do not operate a defective product!
• Always disconnect from the mains before starting work (S4)!
• Never look directly into the LED light source! The light spectrum transmitted may contain blue components (S5).
• Always allow to cool down sufficiently and for cleaning purposes disconnect the luminaire from the power supply
and secure the electric circuit against being switched on again.
• Install only on flat, stable surface!
• Must not be used in areas that represent an explosion hazard (e.g. carpentry workshop, paintshop, or similar)!
• Do not use in the immediate vicinity of flammable materials!
• Do not install in the immediate vicinity of paddling pools, fountains, ponds or similar bodies of water.
• Do not immerse in water or other liquids!
• Do not operate with wet hands!
• The light source in the luminaire is not replaceable. The entire luminaire must be replaced at the end of its
service life!
• Never undertake repairs yourself. Repairs may only be carried out by the manufacturer or an authorised service
representative.
• For the connection, only use regular mains sockets (230V~, 50Hz) with protective conductors of the public
supply network which are easily accessible!
• Do not open the housing! (S4)
• Never operate with an open housing, or missing or damaged terminal compartment cover.
• If the cable is damaged, disconnect product from the power supply!
• De-energised only when the plug is pulled out!
9