REMS Mini-Cobra S Betriebsanleitung Seite 13

eng
5.3. Fault: No feed of the pipe cleaning spiral.
Cause:
● Adjusting wheel (11) was not engaged.
● Pipe cleaning spiral stuck in the pipe or in a pipe blockage.
● Pipe cleaning spiral is not mounted in the spiral drum (10) in clockwise
direction.
● Electric pipe cleaning machine defective.
6. Disposal
REMS Mini-Cobra S, REMS Mini-Cobra S 22 V VE, batteries, rapid chargers
and power supply units may not be thrown in the domestic waste when no
longer used. They must be disposed of properly by law. Lithium batteries and
battery packs of all battery systems may only be disposed of in the discharged
state, all contacts of incompletely discharged lithium batteries and battery packs
must be covered with insulating tape.
7. Manufacturer's Warranty
The warranty period shall be 12 months from delivery of the new product to the
fi rst user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference and in a fully assembled condition. Replaced products and
parts shall become the property of REMS.
Remedy:
● Engage adjusting wheel (11), see 3.1. Operation REMS Mini-Cobra S /
3.2. Operation REMS Mini-Cobra S 22 V VE.
● Set the direction of rotation switch (3) to the arrow in the direction of the switch
handle (2). Turn the side handle with thrust control (Fig.1 (1)) to the left. Press
the safety inching switch (4) lightly so that the spiral drum (10) turns, then
increase the speed slowly as required.
● Remove pipe cleaning spiral and re-mount, see 2.2.
● Have the electric pipe cleaning machine inspected/repaired by an authorised
REMS customer service workshop.
The user shall be responsible for the cost of shipping and returning the product.
A list of the REMS-authorized customer service stations is available on the
Internet under www.rems.de. For countries which are not listed, the product
must be sent to the SERVICE-CENTER, Neue Rommelshauser Strasse 4,
71332 Waiblingen, Deutschland. The legal rights of the user, in particular the
right to make claims against the seller in case of defects as well as claims due
to wilful violation of obligations and claims under the product liability law are
not restricted by this warranty.
This warranty is subject to German law with the exclusion of the confl ict of laws
rules of German International Private Law as well as with the exclusion of the
United Nations Convention on Contracts for the International Sales of Goods
(CISG). Warrantor of this world-wide valid manufacturer's warranty is REMS
GmbH & Co KG, Stuttgarter Str. 83, 71332 Waiblingen, Deutschland.
8. Spare parts lists
For spare parts lists, see www.rems.de → Downloads → Parts lists.
eng
13