Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
2. Operation
-
After filling up the water tank, connect the appliance to the mains: it will start to preheat
and the indicator light will come on. After 30 seconds, the indicator light will go out. After
30 seconds of preheating, you can start using the iron.
-
If you need to iron with steam, press the steam button: the iron will emit steam each time
you press the button (it may be necessary to press it several times during the first use).
4. CLEANING AND MAINTENANCE
NOTE
Make sure the iron is unplugged from the mains before cleaning.
-
Disconnect the appliance from the power supply and allow it to cool down completely
before handling it.
-
Clean the steam outlet with a damp cloth.
-
Do not use harsh or abrasive cleaning agents or solvents.
-
Do not put the garment steamer in water or any other liquid.
-
Always empty the water tank after each use and rinse with clean water.
-
Clean the housing with a damp cloth.
-
Always ensure the steam outlet hole is clean, free from scaling and not blocked.
-
Once the garment steamer is disconnected from the power outlet, cooled down, water
is emptied and the device is clean, it is recommended to wrap the cord safely around the
steamer to store in an upright position.
NOTE
When using the iron for the first time, drops and steam will come out of the soleplate until
the temperature stabilises. Before the first use, pass the iron over a plain fabric several times
until the temperature stabilises. A small number of white specks may come out during the
first use of the steam function, which is normal.
Cleaning water mineral deposits
-
To prevent minerals from building up or reduce them, follow the below recommendations:
-
Carry out this process once every month if not using natural water.
Make sure the appliance is unplugged and cooled down.
1.
Mix a solution of 50% decalcifying agent and 50% weakly demineralised water.
2.
Remove the water tank as indicated before, open the rubber plug, and carefully pour the
3.
solution into the tank. Put the plug back.
Allow it to take effect for 40 minutes and then empty the tank.
4.
Fill the tank with clean water, rinse and empty. Repeat this step until any odour
5.
disappears.
36
IRONHERO 1000 VITAL
Werbung
