IKEA TRIXIG Bedienungsanleitung Seite 9

Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of materials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to a complete stop before placing it down.
The tool insert can jam and lead to loss of control over the power tool.
Avoid unintentional switching on. Ensure the trigger is in the off position before
inserting battery pack. Carrying the power tool with your finger on the trigger or inserting
the battery pack into power tools that have the switch on invites accidents.
Safety Warnings for battery chargers
For indoor use only.
Keep the battery charger away from rain or moisture. Penetration of water in the
battery charger increases the risk of an electric shock.
Do not charge other batteries. The battery charger is suitable only for charging the
batteries that were supplied with your power tool. Otherwise there is danger of fire and
explosion.
Keep the battery charger clean. Contamination can lead to danger of an electric shock.
Before each use, check the battery charger, cable and plug. If damage is detected, do
not use the battery charger. Never open the battery charger yourself. Have repairs
performed only by a qualified technician. Damaged battery chargers, cables and plugs
increase the risk of an electric shock.
Do not operate the battery charger on easily inflammable surfaces (e. g., paper,
textiles, etc.) or surroundings. The heating of the battery charger during the charging
process can pose a fire hazard.
VIBRATION AND NOISE INFORMATION
Vibration and noise level
The vibration and noise emission level stated in this instruction manual has been
measured in accordance with a standardised test in EN 62841. It may be used to compare
one tool with another and as a preliminary assessment of exposure to vibration and noise
when using the tool for the applications mentioned in this manual. However, using the
tool for different applications, or with different or poorly maintained accessories, may
significantly increase the exposure level.
An estimation of the level of exposure to vibration and noise should also take into account
the times when the tool is switched off or when it is running but not being used, as this
may significantly reduce the exposure level over the total working period. Protect yourself
against the effects of vibration and noise by maintaining the tool and its accessories,
keeping your hands warm and organising your work.
Other risks
Even when the power tool is used as prescribed, it is not possible to eliminate all
other risk factors. The following hazards may arise in connection with the power
tool's construction and design:
9