IKEA TRIXIG Bedienungsanleitung Seite 8

d. Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the battery may cause irritation or burns.
e. Do not use a battery pack or tool that is damaged or modified. Damaged or
modified batteries may exhibit unpredictable behaviour, resulting in fire, explosion or
risk of injury.
f. Do not expose a battery pack or tool to fire or excessive temperatures. Exposure to
fire or a temperature above 130 °C may cause an explosion.
g. Follow all charging instructions and do not charge the battery pack or tool outside
the temperature range specified in the instructions. Charging improperly or at
temperatures outside the specified range may damage the battery and increase the
risk of fire.
Service
a. Have your power tool serviced by a qualified repair person using only identical
replacements parts.This will ensure that the safety of the power tool is maintained.
b. Never service damaged battery packs. Service of battery packs should only be
performed by the manufacturer or authorised service providers.
MACHINE-SPECIFIC SAFETY INSTRUCTION
Safety warnings for drills and screwdrivers
1. Safety instructions for all operations
a. Wear ear protectors when impact drilling. Exposure to noise can cause hearing loss.
b. Hold the power tool by the insulated gripping surfaces when performing an
operation where the cutting accessory or fasteners may contact hidden wiring.
The cutting accessory or fasteners contacting a "live" wire may make exposed metal
parts of the power tool conductive and could give the operator an electric shock.
2. Safety instructions when using long drill bits
a. Never operate at a higher speed than the maximum speed rating of the drill bit. At
higher speeds, the bit is likely to bend if allowed to rotate freely without contacting the
workpiece, resulting in personal injury.
b. Always start drilling at low speed and with the bit tip in contact with the
workpiece. At higher speeds, the bit is likely to bend if allowed to rotate freely without
contacting the workpiece, resulting in personal injury.
c. Apply pressure only in direct line with the bit and do not apply excessive pressure.
Bits can bend causing breakage or loss of control, resulting in personal injury.
Use appropriate detectors to determine if utility lines are hidden in the work area or
call your local utility company for assistance.
Contact with electric lines can lead to fire and electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes property damage or may cause an electric
shock.
Switch off the power tool immediately when the tool becomes blocked or stuck. Be
prepared for high reaction torque that can cause kickback. The tool becomes blocked
when:
• the power tool is subjected to overload
• or it becomes wedged in the workpiece.
Hold the machine with a firm grip. High reaction torque can briefly occur while driving
in and loosening screws.
8