Before Using - insta360 Ace pro Gebrauchsanleitung

Before Using

① Before using the Dive Case, please udate your camera's firmware to the latest version.
② Please read this document carefully and prepare the case properly before use. Failure to
observe these instructions may cause damage to the camera, battery, microSD card or other
parts, for which Insta360 won't assume responsibility. Please use this product responsibly to
prevent accidental damage.
③ Improper maintenance may affect product performance. Each time before placing the camera
in the Dive Case, it's suggested to latch the Dive Case (no camera inserted) and immerse it in
water to check for leaks as described below:
• Latch the Dive Case and then slowly immerse it in water, stopping if air is expelled from inside
the Dive Case.
• Immerse the Dive Case and operate the buttons under water for 2-3 minutes, checking for any
air bubbles.
• Take the Dive Case out of the water and dry it thoroughly with a soft, dry cloth, then open the
Dive Case and check for water inside.
④ When sealing the Dive Case, be sure that the parts of the Dive Case in contact with its rubber seal
are free of any foreign objects and the rubber seal has not moved off the rim of the Dive Case.
⑤ Never open or close the Dive Case in a location with a lot of sand, dirt, dust or other small
particles. Otherwise, the performance of the Dive Case will be reduced and the camera may be
damaged.
⑥ The Dive Case is not shock-resistant. Applying strong vibrations, shocks or pressure to the
product may result in damage, failure or reduced waterproofing performance.
⑦ When diving into water with a camera in the Dive Case, the recommended maximum dive height
is 2 meters (6.56ft) above water level. The Dive Case provides camera protection when dropped
on solid surfaces from a maximum dropping distance of 1 meter (3.28ft).
2