Bosch GCA 30-42 Professional Originalbetriebsanleitung Seite 13

– If the modules were not connected before
replacing the coin cell, the connection
needs to be established.
After a reset, the Auto-Start remote and the
receiver must be reconnected.
Auto Starting the Dust Extractor
– Insert the extraction hose into the dust ex-
traction attachment of the cordless tool.
Vibration Detection
The GCT 30-42 transmitter module is
equipped with vibration detection. If it detects
the vibrations of the activated cordless tool,
the dust extractor will switch on automatically.
If you switch off the cordless tool, the dust ex-
tractor switches off automatically after a cer-
tain run-on time.
Switching On and Off Manually
– Briefly press the start/stop button (7) on
the Auto-Start remote (5).
The dust extractor switches on.
Status indications
GCA 30-42: Status Meaning/cause
indicator (2)
Blue – Connection is established
or
– Data is being received
Green – Connection established and
Yellow – Connection interrupted
Bosch Power Tools
– To switch off the dust extractor, press the
start/stop button (7) on the Auto-Start re-
mote again.
Note: If you switch off the dust extractor with
the start/stop button (7) on the Auto-Start re-
mote, the dust extractor will automatically
switch on again once the Auto-Start
remote (5) detects the vibrations of the cord-
less tool.
Resetting to Factory Settings
– Receiver GCA 30-42: Press and hold
the (3) button until the status indicator
with the Auto-Start symbol (2) flashes
blue four times in quick succession.
– GCT 30-42 Auto-Start remote: Press and
hold the start/stop button (7) until the
LED status indicator (6) flashes blue four
times in quick succession.
active
English |
Solution
–
–
– Move Auto-Start remote closer
to the receiver
– Initiate vibration detection or
press the start/stop button (7)
1 609 92A 7U3 | (30.06.2023)
13