Blaupunkt CMP501 Bedienungsanleitung Seite 8

CMP501
line should be released before frothing the milk.
Note: After frothing the milk, clean the steam nozzle with a damp cloth and re-spray the steam for 5
seconds to prevent the milk from drying up and blocking the steam outlet.
If the "Single cup or Double cup coffee" button is pressed immediately after frothing milk, the "Single
cup, Double cup and manual control" button will start flashing, this indicates that the boiler is at too
high a temperature. When the heating element reaches the correct temperature the buttons will
become active.
If no operation is performed within 15 minutes, the machine will switch off automatically.
Personalize your own coffee volume for the one cup of coffee and two cups of coffee buttons.
Once the heating is complete, press and hold the " single or double cup" button for three seconds for
the machine to emit three beeps; when the coffee in the cup has reached the required volume, press
the button again to end the water flow. The coffee machine will beep three times; during this time the
time memory function is set. The coffee brewing time can be set between 8-60 seconds; Once this time
is exceeded, the setting will fail. The next coffee brewing will be according to the previously
programmed value.
Cleaning and maintenance:
1. Disconnect the power until the coffee machine has cooled completely before cleaning.
2. Wipe the outside of the coffee machine and some accessories with a damp cloth or clean sponge.
Note: Do not clean with alcohol or solvent; do not immerse the coffee machine in water when
cleaning.
3 Wash the filter holder including filters under running water. Do not wash the filter holder in the
dishwasher.
Decalcification
1. To ensure the function of the coffee machine, it should be descaled every 1-3 months of use,
depending on the hardness of the water
2 Prepare a 1 litre descaler solution according to the manufacturer's recommendation; if no descaler is
available, citric acid can be used instead (ratio to water is 3:100). Pour the water with the descaling
solution into the water tank.
3. Insert the filter handle into the coffee machine (without coffee), then press the on/off button
4. When the coffee machine has heated up and the buttons are active, turn the steam knob. Place a dish
under the milk frother nozzle. Then press the manual coffee preparation button to pour out 200 ml
of hot water, stop the flow of solution with the manual coffee preparation button. Turn down the
steam knob.
5. Repeat step 4 until all the solution from the water tank has been consumed, with breaks (10min)
between processes, alternating the flow on the steam nozzle and the filter holder.
6. Then rinse the water tank, pour in 1 litre of clean water and repeat the process to rinse the unit.
6