Blaupunkt CMP501 Bedienungsanleitung Seite 7

CMP501
1. control panel
1.1 single cup coffee button
1.2 double cup coffee button
1.3 manual control button
1.4. milk frothing button (steam)
1.5 power button
2. drip grid
3. drip tray
4. coffee filter (for one cup)
5. coffee filter (for two cups)
Preparing for first use
1. Pour water into the water tank (water level should not exceed the "Max" marking).
2. Connect the power supply and then press the on/off button.
3. Wait for the appliance to heat up.
4. Turn the steam knob.
5. Press the manual control button.
6. After flowing approximately 100ml of water, switch off.
7. Wash the filter and filter holder.
USING THE MACHINE
1. Place the selected coffee filter in the filter holder. Note the notch in the filter holder, the bulge on the
filter wall and the notch on the edge of the filter. To slide the filter in or out, the filter notch should be
in the correct position.
2. While the coffee machine is heating up, pour the ground coffee into the filter and stamp it with the
"Coffee Whisking Spoon".
3. Insert the "filter" into the filter holder handle and lock it in line with the tab on the filter holder, then
insert the filter holder handle into the coffee machine and place the cup under the coffee outlet.
4. When the "single cup of coffee/double cup of coffee " button is pressed, the machine will start to
dispense coffee for one or two cups of coffee; the machine will automatically finish brewing coffee.
5. Press the "Manual control button" to prepare the desired volume of coffee as required, then press
the "Manual control button" again to stop coffee dispensing.
6 Turn the filter holder handle from right to left and then remove the filter holder handle. Holding the
filter holder handle and securing the filter with the filter holder(7), remove the coffee grounds and
then clean the filter thoroughly.
7. When the steam button (1.4) is pressed, the indicator light will flash, wait until the light changes
from flashing to steady on; then the pre-heating is complete.
8. Pour the milk into 1/3 of the container, insert the steam nozzle into the milk to a depth of 1 cm, then
slowly unscrew the "steam knob" until steam starts to flow out.
9. When the temperature of the milk reaches about 75 degrees, the milk froth will start to expand; then
turn off the "Steam knob" and the "Steam button".
10. Finally, switch off the coffee machine with the "On/Off" button.
If the coffee machine is not used for a long time, empty the water tank and switch it off. Clean it before
the next use.
Note: The amount of steam can be adjusted to suit your needs. A small amount of water in the steam
6. Filter holder
7. Filter holder
8. Filter holder handle
9. Coffee spoon with stamp
10. Steam nozzle flange
11. Steam nozzle
12. Steam knob
13. Water tank
14. Water tank lid
5