Werbung
Verfügbare Sprachen
Verfügbare Sprachen
cutting operation to check that there are no problems
such as a clamp interfering with the cutting action.
9. Hold the operating handle
lock-off lever
(19)
to left meanwhile
trigger (18). Allow the blade to reach maximum speed
and slowly lower the blade into and through the
workpiece.
10. Release the switch trigger
blade to stop rotating before raising the blade out of the
workpiece. Wait until the blade stops before removing
the workpiece.
To Slide Cut Wide Boards
To slide cut wide boards,
and allow the cutting head assembly to move freely.
SETTING CUTTING DEPTH
The depth of cut can be preset for even and repetitive
shallow cuts.
1. Slide the stop plate
(26)
2. Loosen the lock nut to free the lock knob, turn the
stop knob
until the cutting head down until the
(25)
teeth of the blade are at the desired depth.
3. While holding the upper arm in that position,
tighten the lock nut to secured the stop knob.
Recheck the blade depth by moving the cutting
4.
head front to back through the full motion of typical
cut along the control arm.
MAINTENANCE
1. Store the tool, instruction manual and accessories in a
secure place. In this way you will always have all the
information and parts on hand.
2. Keep the tool's air vents unclogged and clean at all
times.
3. Remove dust and dirt regularly. Cleaning is best done
with compressed air or a rag.
4. Never use caustic agents to clean plastic parts.
GENERAL INSPECTION
1. Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
WARNING :
If any part that is damaged, it should be properly
repaired or replaced by an authorised service
(3)
firmly and
moving the
squeeze the switch
(18)
and allow the saw
Unlock the slide lock knob
towards the front position.
agency! Don't modify, remove the tool parts and
screws , which will result unexpected risk. All
screws shall be well fixed before use!
SERVICE
•
Tool service must be performed only by qualified
repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury.
•
When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section of
this manual. Use of unauthorized parts or failure to
(2)
follow Maintenance Instructions may create a risk of
electric shock or injury.
Werbung
