Werbung
Verfügbare Sprachen
Verfügbare Sprachen
p) Let the blade reach full speed before
contacting the workpiece. This will reduce the
risk of the workpiece being thrown.
q) If the workpiece or blade becomes jammed,
turn the mitre saw off. Wait for all moving parts to
stop and disconnect the plug from the power
source and/or remove the battery pack. Then
work to free the jammed material. Continued
sawing with a jammed workpiece could cause loss of
control or damage to the mitre saw.
r) After finishing the cut, release the switch, hold
the saw head down and wait for the
blade to stop before removing the cut-off piece.
Reaching with your hand near the coasting blade is
dangerous.
s) Hold the handle firmly when making an
incomplete cut or when releasing the switch
before the saw head is completely in the down
position. The braking action of the saw may cause
the saw head to be suddenly pulled downward,
causing a risk of injury.
SAFETY INSTRUCTIONS FOR THE
HANDLING OF SAW BLADES
1. Only use insertion tools if you have mastered their
use.
2. Observe the maximum speed. The maximum
speed specified on the insertion tool may not be
exceeded. If specified, observe the speed range.
3. Observe the motor / saw blade direction of
rotation.
4. Do not use any insertion tools with cracks. Sort
out cracked insertion tools. Repairs are not
permitted.
5. Clean grease, oil and water off of the clamping
surfaces.
6. Do not use any loose reducing rings or bushes for
the reducing of holes on saw blades.
7. Make sure that fixed reducer rings for securing
the insertion tool have the same diameter and have
at least 1/3 of the cutting diameter.
8. Make sure that fixed reducer rings are parallel
to each other.
9. Handle insertion tool with caution. They are
ideally stored in the originally package or special
containers. Wear protective gloves in order to
improve grip and to further reduce the risk of injury.
10. Prior to the use of insertion tools, make sure that
all protective devices are properly fastened.
11. Prior to use, make sure that the insertion tool
meets the technical requirements of this electric tool
and is properly fastened.
12. Only use the supplied saw blade for cutting
wood and or wood-like products, never for the
processing of metals.
RESIDUAL RISKS
Even if you use this electric power tool in accordance
with instructions, certain residual risks cannot be
rules out. The following hazards may arise in
connection with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust mask is
used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
Werbung
