Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAFETY RULES FOR LASER LIGHTS
The laser light/laser radiation used in the system is
Class 2 with maximum 1mW and 650nm
wavelengths. These lasers do not normally
present an optical hazard, although staring at the
beam may cause flash blindness.
WARNING. Do not stare directly at the laser
beam.
A hazard may exist if you deliberately stare into
the beam, please observe all safety rules as
follows;
·The laser shall be used and maintained in
accordance with the manufacturer's instructions.
· Never aim the beam at any person or an object
other than the workpiece.
·The laser beam shall not be deliberately aimed
at personnel and shall be prevented from being
directed towards the eye of a person for longer
than 0.25s.
· Always ensure the laser beam is aimed at a
sturdy workpiece without reflective surfaces. I.e.
wood or rough coated surfaces are acceptable.
Bright shiny reflective sheet steel or the like is not
suitable for laser use as the reflective surface
could direct the beam back at the operator.
· Do not change the laser light assembly with a
different type. Repairs must be carried out by the
laser manufacturer or an authorised agent.
CAUTION. Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
WARNINGS.
-
Do not stare directly at the laser beam. Never
aim the beam at any person or an object other
than the workpiece.
-
Do not deliberately aim the beam at personnel
and ensure that it is not directed towards the eye
of a person for longer than 0.25s.
-
Always ensure the laser beam is aimed at a
sturdy workpiece without reflective surfaces.
Wood or rough coated surfaces are acceptable.
Bright shiny reflective surfaces are not suitable
for laser use as the reflective surface could
direct the beam back at the operator.
-
Always remember to switch off the laser on/off
switch
(36)
after finishing a job. Only turn the
laser beam on when the workpiece is on the
mitre saw table.
-
Mark the line of the cut on the workpiece.
Werbung
