Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mount the washer and upper nut.
After all legs have been installed, set the height of the machine and level it horizontally by adjusting the underlying
nuts. After levelling the machine tighten the upper nuts. When tightening the upper nut the underlying nut has to
be secured.
Connect the machine to the voltage supply. Ensure that the voltage of the machine voltage corresponds to the line
voltage! Start the machine pushing START button and check the drive turning direction.
8.1 Electrical connection
Use STOP button. Attention! Motor runs down. After connection with electric supply the turning direction must
correspond to the arrow direction (see on the picture). If the direction does not correspond, change the phases on
electric terminal board reciprocally. Disconnect machine from electric supply before you start working!
•
Service voltage:
Total input:
•
Max. fuse:
•
Before connecting the machine, switch off the line and make sure to have a dry place fur doing connecting works!
Service voltage must correspond to the line voltage! Crosscut of the supply line must correspond to the rated
current for max. machine load. Connect the power cord of the machine on the clamps of the electric distribution.
T h e s o c k e t w i t h t h e f o r k c a n b e u s e d o n l y a t t h e m a c h i n e s w i t h t h e r a t e d c u r r e n t l e s s t h a n 1 6
A a n d t o t a l i n p u t l e s s t h a n 3 k W .
In case the machine is connected direct to the line, an extra lockable main switch must be added.
Check machine function. Check if the machine or some parts of the machine were damaged during transport.
A t t e n t i o n ! I n t h i s c a s e t h e e x t r a m a i n s w i t c h b e c o m e s p r i m a r y a n d t h e m a i n s w i t c h o n t h e
m a c h i n e h a s o n l y s e c o n d a r y f u n c t i o n .
Check if covers are installed and functional. Turn on without material. Check if the machine runs with no
irregularities. If all machine functions are right, the machine is ready for use.
373153 D/GB
GB
~ 3×400 V, 50 Hz, TN-C-S
2,4 kW
8 A
18
Werbung
