Herunterladen Diese Seite drucken

Werbung

Installation instructions
en
Instructions d'installation
fr
de
Hinweise zur Installation und zum Aufstellungsort
it
Istruzioni di installazione
ro
Instrucțiuni de instalare
tr
Montaj Talimatları
K54306B_HB – Sliding LH
4578347915/AB

Werbung

loading

Inhaltszusammenfassung für Beko BCSA306K2SLH

  • Seite 1 Installation instructions Instructions d’installation Hinweise zur Installation und zum Aufstellungsort Istruzioni di installazione Instrucțiuni de instalare Montaj Talimatları K54306B_HB – Sliding LH 4578347915/AB...
  • Seite 2 Spares included Pièces incluses Ersatzteile inklusive Ricambi inclusi Piese incluse Dahil olan parçalar...
  • Seite 3 X>10 mm X<10 mm see page 4; voir page 4; siehe Seite 4; vedi pagina 4; vezi pagina 4; sayfa 4'e bakın; - If the subject parts are not included in the product you have purchased, then it is valid for other models. - Si les pièces concernées ne sont pas incluses dans le produit que vous avez acheté, elles sont valables pour d'autres modèles.
  • Seite 4 min. 200 cm No wooden back wall min. 200 cm The back wall of the wooden cabinet must be left open completely to kitchen wall in order to allow sufficient air circulation to cool down the condenser unit for energy efficiency. La paroi arrière du meuble en bois doit être laissée complètement ouverte contre le mur de la cuisine, afin de permettre une circulation d’air suffisante pour refroidir le produit.
  • Seite 5 min. 200 cm mm * 4 mm min. 200 cm...
  • Seite 7 Note: screws for connecting top plastic part should not be screwed very hard, because of moving the plastic part easily left or right side. Remarque: les vis pour fixer l’accessoire en plastique sur la partie supérieure ne doivent pas être vissées à fond, afin d’éviter tout déplacement latéral de cette pièce pendant le vissage.
  • Seite 8 Installation step for 7: screws should not be fully tightened at this stage. A l'étape 7 de l'installation: les vis ne doivent pas être vissées à fond. Installationsschritt 7: die schrauben sollten nicht zu fest angezogen werden. Fase di installazione per 7: le viti non devono essere completamente serrate in questa fase. Instalarepasul 7: șuruburile nu ar trebui să...
  • Seite 11 Adjusting the legs If yourrefrigeratoris unbalanced: You can balance your refrigerator by turningthe legs of itas illustratedin the figure. The corner where the leg existsis loweredwhenyou turnin the direction of black arrow and raisedwhenyouturnin the opposite direction. Takinghelp from someoneto slightlylift the refrigerator willfacilitatethisprocess. Réglage des pieds Si votre réfrigérateur est déséquilibré: Vous pouvez l’équilibrer en tournant les pieds de celui-ci comme illustré...
  • Seite 12 42 mm Installation step for 13: screws should not be fully tightened at this stage. A l'étape 13 de l'installation: les vis ne doivent pas être vissées à fond. Installationsschritt 13: die schrauben sollten nicht zu fest angezogen werden. Fase di installazione per 13: le viti non devono essere completamente serrate in questa fase. Instalare pasul 13: șuruburilenu ar trebui să...
  • Seite 13 X<10 mm CLICK CLICK...
  • Seite 15 Ø2 21 mm...
  • Seite 16 Note: Installation step for 6*, 7*, 13* and 16* - only for Italy models. Remarque: A l'étape 6*, 7*, 13* et 16* de l'installation - uniquement pour les modèles italiens. Hinweis: Installationsschritt 6*, 7*, 13* und 16* - nur für Italien Modelle. Nota: Fase di installazione per 6*, 7*, 13* e 16* - solo per i modelli italiani.

Diese Anleitung auch für:

Bcha275e4sn