Werbung
BATTERY AND CHARGER
Faults
If a fault is present, the red LED, the message "FAULT" and the Wrench symbol will be flashing
and the fault number is showed in the upper 3-digit field.
Code
Description
17
Battery voltage too low
23
Power supply is missing
16
Controller overheated
22
39
Error main relais
For other error codes, contact your dealer.
Charging
Please be aware that the mains voltage corresponds the mains voltage, indicated on the
charger.
Built-in charger (12V and 24V):
1.
Connect the charger to the mains.
2a. 12V charger: The charging diode flashes during charging. Charging is continued until the
charging diode is on constantly. A fully charge normally takes 8 hours.
2b. 12V charger: The charging diode is red during charging. Charging is continued until the
charging diode is on green. A fully charge normally takes 8 hours.
3.
24V charger: The diode of the charger is placed next to the battery info display.
When the charging starts, the green diode flashes.
When the battery is fully charged, the green diode is alight.
Please note! When connected to the mains, the driving functions of the truck are
disconnected (truck with propulsion).
4.
If the charger stays connected, the charging process will end after finished charging, and
the charger will change to equalising charge.
If the battery has not been fully charged after 18 hours of constant charging, the charger
is switched off automatically.
Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com
Solution
Charge battery
Check fuses
Contact the dealer
Contact the dealer
ENGLISH
S1020
7
Werbung
