Werbung
BATTERY AND CHARGER
Checking the battery conditions
The battery condition for closed batteries appears from the battery indicator.
The battery voltage can be measured with a voltmeter (DC) on the poles of the battery.
Do not use the battery half an hour before measuring.
By two batteries connected in series (24V), the voltage difference between the two batteries is
not allowed to exceed 0.1V.
Battery indicator - 12V
The battery indicator shows the charging condition.
The most accurate reading can be obtained, after the battery has been allowed to remain idle
for 5-10 minutes.
Red diode is on: Do not use the product. The battery can be permanently damaged.
The first green lamp is on: The product can still be used; Charging is recommended.
Charging- V1: The charging diode flashes during charging. Charging is continued until the
charging diode is on constantly.
Charging- V2: The charging diode is red during charging. Charging is continued until the
charging diode is on green.
CHARGING
4
S1020
Battery voltage
12 Volt
Ca. 12,9 V
Ca. 12,3 V
V1
FINISHED
Charging diode
24 Volt
Ca. 25,8 V
Fully charged
Ca. 24,5 V
80% discharged
V2
CHARGING
Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com
ENGLISH
FINISHED
Werbung
