cecotec BAMBA TOOTHCARE JET CLEAN Bedienungsanleitung Seite 21

ENGLISH
4. ELECTRIC TOOTHBRUSH OPERATION
Charging instructions
- Make sure the appliance is switched off before charging. Place the toothbrush on the
charging base and make sure the latter is plugged into the mains socket. If the charging
indicator light flashes, it means the toothbrush is charging. Charging is complete when the
charging indicator light stops flashing and switches to steady.
- The charging indicator light may not light up instantly when the toothbrush is charged
after a long period of inactivity. It should light up in 6-10 minutes.
- If the brush wasn't used for more than 6 months, charge it for at least 12 hours to reach a
full charge.
Tips to extend battery life
- Completely charge the battery before first use.
Do not recharge the brush between brushings after the first charge. Recharge it once the
-
battery runs out.
- Completely empty the appliance at least once a year.
Using the electric toothbrush. Fig. 8
- Insert the toothbrush head onto the drive shaft.
- Wet the bristles and apply some toothpaste.
- Place the bristles against the teeth at 45 degrees to the gumline.
Switch on the toothbrush by pressing the power/mode button, and select the mode that
-
best suits your needs by repeatedly pressing the button.
- Move the bristles slowly in a circular motion. Do not scrub your teeth; instead, apply light
pressure and let it do the brushing for you.
Then hold down the button for 3 seconds to turn off the toothbrush. The toothbrush will
-
automatically switch off after two minutes.
- Rinse your mouth with water after brushing.
Operating modes:
- Clean: suitable for daily toothbrushing.
- White: ideal for tooth whitening.
- Sensitive: ideal for sensitive teeth.
Massage: to get a gentle massage while brushing.
-
- Gum Care: suitable for gum care.
It is recommended to replace the toothbrush head every three months.
Toothbrushing time
- The timer reminds you to change oral zones every 30 seconds for a complete brushing.
- 2 minutes is the recommended toothbrushing time.
40 BAMBA TOOTHCARE JET CLEAN
5. CLEANING AND MAINTENANCE
Cleaning
Cleaning the water flosser
- After adding special solutions to the tank, clean it thoroughly:
Half fill up the tank with warm tap water. With the tip pointing towards the sink, turn the
-
appliance on and let it run until the tank is completely empty: this will help prevent the tip
from clogging and help the appliance last longer.
- Unplug the appliance before cleaning the exterior surface.
If necessary, clean the appliance with a soft cloth and a non-abrasive cleaning agent.
-
Cleaning the toothbrush head
Rinse the toothbrush head after every brushing and let it air dry. Do not rub the bristles to
avoid deformation.
Cleaning the toothbrush handle
- Rinse and let it air dry.
Do not immerse the toothbrush in water or other liquids.
-
- Do not clean the toothbrush with water above 40 °C or with abrasive cleaning agents.
Replacing the toothbrush head
Dental professionals recommend replacing the toothbrush head every 3 months for best
-
brushing results.
- Replace the toothbrush head as well when the bristles start to bend outwards.
Maintenance and repair
- After using the water flosser, be sure to unplug the power cable, and place the tank upside
down on a flat surface. When completely dry, put it in a cool, dry place along with the body,
also dry and clean. You must place it in the original box or a similar one when it is not going
to be used for a long time.
- Before exposing the appliance to low temperatures, remove the tank and use the appliance
until completely empty. Empty the tank also if the appliance is going to be stored for a long
period of time.
If the appliance does not work properly, contact the official Cecotec Technical Support
-
Service.
- Do not try to disassemble or repair the appliance. If this causes any problems with the
appliance, the warranty will not cover it.
ENGLISH
BAMBA TOOTHCARE JET CLEAN 41