Werbung
Verfügbare Sprachen
Verfügbare Sprachen
17
SPEED
LOW
HIGH
SINGLE
NOR
PROG
REP/ RAN
15
16
18
1
2
3
6
7
8
25
Buttons on the player
4 Installation
4.1 Setting up / Installation into a rack
Place the player on a flat, horizontal surface or
use the two mounting brackets to insert it into
a rack for devices with a width of 482 mm (19") .
In the rack, one rack unit (1 U = 44 .45 mm) is
required .
Put the Bluetooth antenna (4) in a vertical
position .
4.2 Connections
Before connecting or disconnecting, switch off
all devices involved .
1) The stereo audio signal of the player is avail-
able at the RCA output (3): Connect the
output to the line input of an amplifier (or
another device that follows, e . g . a mixer) .
A suitable cable is provided .
Note: When an audio source is connected to the
input AUX IN (11), the output will receive the audio
signal from the audio source (
2) For remote control of the player via a com-
puter, connect the 9-pole D-Sub connector (1)
to the RS-232 interface of the computer (if
no RS-232 interface is available on the com-
puter, use an adapter "USB to RS-232") . The
parameters for the RS-232 interface and the
control commands can be found in chapter 6 .
21
23
19
FOLDER
PLAY/
A > B
SKIP
PREV
NEXT
STOP/ EJ
MODE
20
22
24
4
5
CD/CARD
9
0
MEMORY
26
chapter 5 .1) .
☞
SPEED
15
LOW
1
4
25
7
– FOLDER –
19
A B
MODE
24
27
POWER
CD / CARD
26
MEM.
Buttons on the remote control
3) To ensure operation of the player in the event
of a mains failure, connect the screw ter-
minals (5) to an emergency power supply
( ⎓ 24 V) .
Note: When a 24 V emergency supply voltage is
applied to the terminals, the player will be on,
regardless of the position of the switch POWER .
If the mains supply is also present when the
emergency supply voltage is applied, the switch
POWER will switch between emergency power
operation (position OFF) and mains operation (po-
sition ON) .
4) Use the mains cable provided to connect the
IEC connector (6) to a mains socket .
4.3 Activating / D eactivating
the automatic start function
The switch AUTOPLAY (2) is used to activate or
deactivate the automatic start function: When
the function has been activated (upper position
ON), the player will read the medium (CD, USB
storage device, SD card) and automatically start
playing . When the function has been deacti-
vated (lower position OFF), the player will read
the medium and go to stop mode .
With the player switched off, set the switch
AUTOPLAY to the desired position and then
switch the player on again .
EJECT
NOR
HIGH
22b
2
3
16
PROG
SINGLE
5
6
17
RANDOM
8
9
REPEAT
18
STOP
PLAY
/
I I
0
22a
21
REV. – SKIP – F.WD
20
ENTER
23
28
29
VOLUME
−
+
30
19
Werbung
