Installation; Electrical Connection / Start-Up - Helios Rvmd-Serie Montage- Und Betriebsvorschrift

Installation and Operating Instructions
m
NOTE
CHAPTER 5

INSTALLATION

m
DANGER
nmr
n
m
DANGER
ATTENTION
Round duct shutter motorised – RVMD..
NOTE!
In case of strong vibrations and/or odours, maintenance must be carried out by a specialist according to
chapter 1.5.
All of the following information and instructions are intended solely for
authorised electricians!
5�1 Installation
m
DANGER!
Touching live parts will lead to electric shock.
Isolate the unit from the mains power supply before connection!
During installation, the applicable occupational safety and accident prevention regulations as well as the safety requi-
rements of the Equipment Safety Act must be observed. Suitable protective equipment should be used. Installation is
only to be carried out by qualified personnel.
m CAUTION!
The round duct shutter RVMD.. can fall down
Secure the round duct shutter RVMD.. to prevent it from falling
m CAUTION!
Fingers can be crushed between the drive and the shaft of the round duct shutter RVMD...
Placement, arrangement must be out of reach of laymen. Wear personal protection equipment.
5�2

Electrical connection / Start-up

m
DANGER!
Touching live parts will lead to electric shock.
Isolate the unit from the mains power supply before connection!
Carry out all work in a de-energised state. The electrical connection may only be carried out by an authorised electrician
according to the wiring diagram enclosed with the unit.
The relevant safety, installation and maintenance regulations must be observed. The rated voltage and frequency must
correspond to the rating plate information.
– The electrical connection and initial start-up must only be carried out by qualified electricians
according to the information in the attached wiring diagrams.
– All relevant standards, safety regulations (e.g. DIN VDE 0100), as well as the technical connection conditions of
energy suppliers are to be adhered to!
– A multipole mains section switch/isolator, with a minimum contact opening of 3 mm (VDE 0700 T1 7.12.2/
EN 60335-1) is mandatory!
– Network configuration, voltage and frequency must be consistent with the rating plate information.
– Check the waterproofing of the connection cable and tight clamping of the strands
– Metal cable screws must not be used when connecting to plastic terminal boxes.
– Insert the supply line so that no water can get in along the cable in case of water exposure.
– Check designated use
– Check solid mounting and professional electrical installation of round duct shutter RVMD.
– Check all parts for tightness, particularly screws, protection guards. Do not loosen screws in the process!
5
EN