eco touch RC-EX1A Installationsanleitung Seite 7

④ 
W hen wires are passed through the bottom case, fix the bottom case at 2 places on the switch box.
Switch box
for 1 pc
Wire outlet Wire outlet
⑤ 
W hen fixing the bottom case diagonally at 2 places, cut out the
thin wall section on the case.
⑥ 
F ix wires such that the wires will run around the terminal screws
on the top case of R/C.
Cautions for wire connection
Use wires of no larger than 0.5 mm
wiring running through the remote
control case, Take care not to pinch
the sheath.
Tighten by hand (0.7 N·m or less)
the wire connection. If the wire is
connected using an electric driver, it
may cause failure or deformation.
⑦
Install the upper case with care not to pinch wires of R/C.
In case of exposing wiring
③  
C ut out the thin wall sections on the cases for the size of wire.
Upper center
Upper case
Upper side Upper side
Switch box
for 2 pcs
Bottom case Bottom case
Downside Downside
2
for
(When the wiring is taken out from the "upper center" or "upper left" of R/C)
Upper left
Upper side Upper side
Bottom case Bottom case
8
Downside Downside
Wire outlet Wire outlet
Wiring hole on bottom case
When taking the wiring out from the upper center,
open a hole before separating the upper and
bottom cases. This will reduce risk of damaging
the PCB and facilitate subsequent work.
When taking the wiring out from the upper left,
take care not to damage the PCB and not to
leave any chips of cut thin wall inside.
Bottom case
— 6 —
Wall
Cut out the thin Cut out the thin
wall part at the wall part at the
Bushing
screw mounting screw mounting
section with a section with a
50
knife or the like knife or the like
before tightening before tightening
the screw. the screw.
200
Conduit
Locknut
Switch bo
Seal with p
R/C cable