Opening/Closing The Implement - Electrodrive Cdc; Open/Close The Implement - Hose Kit; Operating Instructions; Bale Spike - Quicke Flexibal Originalbetriebsanleitung

Driving instructions
4.2.4. Opening/closing the implement -
ElectroDrive CDC
To open and close the implement, use the third hydraulic
service which is controlled by switch P2.
When the lever is moved to the right (5) the implement is
opened, and when moved to the left (4) the implement is
closed (right-hand fitting).
The movements are reversed for left-hand fitting.
When the switch for the third hydraulic service is released
then the control immediately returns to the dump/roll back
function.
4.2.5. Open/close the implement - Hose
kit
Hose kit - tractor Joystick, see the instruction manual for
the tractor.

4.2.6. Operating instructions

The implement is designed for handling round bales (max.
diameter 172 cm). The rollers reduce the risk of damage to
the plastic packaging. Make sure that the rollers engage the
bale as low as possible (the rollers should therefore NOT
clamp the bale).

4.2.7. Bale spike

The rollers (1) are bearing-mounted on the tine (2). By
removing the screw (3), the roller can be removed. The
attachment can then be used as a bale spike.

4.2.8. Parking the implement

Disconnect the attachment with the rollers as wide apart
as possible, but not with the cylinder in the end position
- difficulties may arise due overpressure next time quick
couplings are connected.
See also the chapter "Connection and disconnection of the
implement" in the loader operating manual.
P2
5
4
0222-x
Fig.23 Opening/closing the implement - ElectroDrive CDC
Fig.24 Operating instructions
3
2
Fig.25 Bale spike
14
5
4
0224
1
0228