Carson Dragster Brushless-Set Turbo Betriebsanleitung Seite 13

SPECIFICATIONS
60A Controller
Continuous / peak Current 60A / 360A
Motor Type / Sensorless Brushless Motor for
Battery 2S Lipo or 6 cells NiMH:
1. KV<= 3300: ON-Road / OFF-Road
2. KV<= 4370: ON-Road / OFF-Road
TROUBLESHOOTING
1. If after power on, motor can't work, no sound is emitted, please check the connections between
battery pack and motor.
2. If after power on, LED flashes, please check the voltage of battery pack, which should be from
5V-13V.
3. If the motor emits a "Beep-Beep" tone Only, please check all the connections: BEC wires,
transmitter and receiver, throttle signal wires, etc. please check the transmitter TH.TRIM and
adjust it to the motor re-emits "Beep-Beep" tone.
4. If the car can't be speed up, please check either voltage of the battery pack is too low or the
temperature of ESC is too high. If the voltage of the battery pack is too low, please replace the
battery pack. If the temperature of ESC is too high, please let cool down. If not, please push the
button EPA on your remote control.
5. If the car stops suddenly while in working state, please check the motor's connections.
6. If the car runs in the opposite direction, which the transmitter is available, please swap two wire
connections between the ESC and the motor.
Battery 3S Lipo or 9 cells NiMH:
1. KV<=3300: ON-Road / OFF-Road:
2. KV<=4370: ON-Road / OFF Road - NO!
13 // GB