Recognising And Repairing Of Mistakes; Notes On Product Liability; Notes On Disposal; Eu Declaration Of Conformity - profi-pumpe SCREW-STAR 1100-7 Bedienungsanleitung

8. RECOGNISING AND REPAIRING OF MISTAKES

Problem
Pump runs, no water is being
pumped
Pump does not start or switches
itself off
Pump runs, Pump capacity slows
down or stops
When you turn on the pump the
FI switch triggered

9. NOTES ON PRODUCT LIABILITY

We point out, that we are only liable for damages under the Product Liability Act, which are caused by our units if no
changes were made to the equipment. If repairs are carried out by our authorized service, we are only liable if original
spare parts and accessories were used.

10. NOTES ON DISPOSAL

Electro devices of our company, labeled with the symbol of the crossed trash bin, are not permitted to
be disposed in your household garbage. We are registered at the German registration department EAR
under the WEEE-No. DE25523173. This symbol means, that you're not allowed to treat this product as
a regular household waste item – it has to be disposed at a recycling collection point of electrical devices.
This is the best way to save and protect our earth.
THANK YOU FOR YOUR SUPPORT!

11. EU DECLARATION OF CONFORMITY

The products listed overleaf accordance with the marketed in accordance with the relevant provisions listed below, the
relevant EU directives and harmonized with EU standards for safety. This declaration is valid insofar on the product,
no changes are made.
Authorized person to keep the technical documents:
1A-Profi-Handels GmbH · Unterriethstraße 37 · D-65187 Wiesbaden
Low Voltage Directive (2006/95/EC)
EC Electromagnetic compatibility directive (2004/108/EC)
EN ISO12100:2010, EN 60204-1:206+A1:2009, EN809:1998+A1:2009
EN60335-1:2002+A1:2004+A2:2006+A12:2006+A13:2008+A14:2010+A15:2011
EN60335-2-41:2003+A1:2004+2:2010, EN55014-1:2006+1:2009, EN61000-3-3:2008
EN55014-2:1997+A1:2001+A2:2008, EN61000-3-2:2006-A1:2009+A2:2009
Wiesbaden, 1st October 2017
ppa. Peter Neumüller
Possible cause
Air in the system (cannot escape)
Impeller wheel is blocked
Engine guard has switched the pump off
No electricity
Pump is inserted to deep
Hose connections systems have a leak
Impeller wheel is worn down
Filter has become dirty
Pump leaks
Condensation in the electrical connection /
terminal box
English 5
Solution
Air in the system must be let out
Impeller wheel must be cleaned
Pump needs to be cooled
Check electrical connections
Insert pump not so deep
Check hose connection systems
Change impeller wheel
Clean filter
examine pump moisture damage
Disconnect from mains plug /
Information to supplier