Storch Crossline Originalbetriebsanleitung Seite 23

6. Direct the vertical laser lines onto the provided position by turning the upper housing part of the device into the desired position. Pre-
cisely adjust the vertical lines onto the desired position by means of the rotating fine adjustment mechanism (pos. 7).
Please note: the fine adjustment mechanism is only used for fine adjustment of the targeted mark and not for a complete 360 degree
rotation.
7. If the laser beam flashes while the device is switched on, the angle of the device is too large; readjust the three screws of the tripod
/ wall mount accordingly.
8. If the line laser angle exceeds the limit for some reason during operation, the laser beam will automatically start to flash. In this case
use the three levelling screws (in case of the tripod and wall mount mounting readjust the respective holding device) to adjust the set-
ting until the laser beam stops flashing.
Possibly, reasons for setting changes can be too strong vibrations or impacts in the installation area of CrossLine. In this case make
sure that the malfunction causes are eliminated.
GB
9. Usage of the device after interruption of operation. By means of the plumbline beam projected by the device from the bottom of the
housing onto the ground it is possible for you to mark the installation position for being able to set up the device subsequently on the
same position. You will be able as well to mark the position of the vertical and horizontal laser lines in order to be able to restore the
last known position easier.
Care and maintenance
1. Never attempt to open the CrossLine. Only qualified STORCH service partners are allowed to repair the device.
2. To guarantee precision, protect the line laser against dropping, knocks and impacts.
3. When storing the device for an extended period of time, remove the batteries from the battery compartment.
4. Clean the device with a soft cloth and a mild detergent.
5. Never use aggressive chemicals, petroleum ether or cleaning agents, and do not keep the device in a dusty or heavily contaminated
environment.
6. Clean the red lenses with a spectacles cleaning cloth.
Warranty
Warranty conditions:
A warranty period of twelve months from the date of purchase/date of invoice applies to our tools for commercial customers. If we have
granted an extended warranty period, this period will be noted separately in the operating manual for the equipment in question.
Claims:
If you wish to claim under our warranty or guarantee, please return the complete device and your invoice to our logistics centre in Ber-
ka, postage paid, or send it to one of our authorised service centres. Before doing so, please contact your STORCH sales consultant.
Your rights under our warranty or guarantee:
Claims can only be accepted for material defects or manufacturing errors, and only assuming intended use of the appliance. Wear
parts are not covered by such claims. All claims shall become void in the event of installation of third party components, improper
handling and storage, as well as in the event of obvious disregard of the operating instructions.
Repairs:
All repairs have to be conducted on our premises or by an authorised STORCH service centre.
Disposal
End-of-life devices must not be disposed of as domestic waste. Please take them to a suitable collection point for recycling or hand
over the end-of-life device to your specialist dealer.
23