Storch Crossline Originalbetriebsanleitung Seite 22

Device description
CrossLine cross line lasers with well visible laser lines are excel-
lent for aligning tiles, framework, windows, doors etc.
1.
Key control panel
2.
4. Laser exit window for vertical laser
3.
On/off switch
4.
Battery cover
5.
1. Laser exit window for horizontal laser
6.
Carrying belt
7.
Fine adjustment of the vertical laser lines with spirit-level
8.
3. Adjustable feet with levelling screws
9.
Plumbline laser and tripod thread with 5/8"
Control Panel
1.
Key Vertical line "V"
2.
Control LED
3.
Key horizontal line "H"
4.
Dimmer button "bulb icon" bright / dark
Operation
1. Remove the battery compartment cover (pos. 4), insert three 1.5 V (AA) Alkaline batteries into the battery compartment observing
the + and - polarity signs; then reposition the battery compartment cover.
2. CrossLine can be used as a standing device and is to be positioned onto a stable and vibration-free support. In case of need and
in case of levelling work at a determined height it can be mounted onto the corresponding holding devices. (Optionally onto the tripod
(item no. 441505) or at the wall bracket (item no. 441512)). If you use a tripod, hold the centring nut on the device in one hand and
turn the screw on the tripod into the centring nut on the device. Tighten the screw. In case of using the wall bracket position the device
onto the supporting arm and tighten from below by means of the locking screw of the wall bracket.
3. Switch on the device (pos. 3): this switches on the power supply and the supporting laser diode bracket in the inside of the housing
is unlocked at the same time to allow for automatic self-levelling. (Switch off the device: the power supply is switched off and the laser
diode bracket is automatically locked).
4. Adjust the three levelling screws so that the spirit-level bubble in the base is in the black circle.
Please note: the spirit-level is only used as an aid for levelling the CrossLine. Levelling of the laser diodes is handled internally and is
independent of the spirit-level.
5. The laser diodes can be switched on via the control panel. The vertical lines can be activated individually by actuating the "V-button":
press 1 x - 1 vertical lasers on, press 2 x – 2 vertical lasers on, forming an angle of 90 degrees, press 3 x – all 4 vertical lasers on. The
horizontal line is switched on by actuating the "H-button". In case of need you increase the luminosity of the laser diodes by means of
the dimmer button "bulb icon".
22
1
2
3
5
7
Translation of the original instruction
4
6
8
9