Eaton E5496E040 Serie Bedienungsanleitung

Operating Instructions
Electronic Display Counter
E5496E040x Series
1.1 Safety instructions and warnings
Only use this display
– according to its intended purpose
– if its technical condition is perfect
!
– adhering to the operating
instructions and the general
safety instructions.
1.2 General safety instructions
1. Before carrying out any installation or mainte-
nance work, make sure that the power supply
of the digital display is switched off.
2. Only use this digital display according to its
intended purpose:
If its technical condition is perfect.
Adhering to the operating instructions and the
general safety instructions.
3. Adhere to country or user specific regulations.
4. The digital display is not intended for use in
areas with risks of explosion and in the
branches excluded by the standard EN 61010
Part 1.
5. The digital display shall only be operated if it
has been correctly mounted in a panel, in
accordance with the chapter "Technical data".
1.3 Use according to the intended
purpose
The digital display may only be used as a panel-
mounted device. Applications of this product may
be found in industrial processes and controls,
in manufacturing lines for the metal, wood,
plastics, paper, glass, textile and other process-
ing industries.
Over-voltages at the terminals of the digital dis-
play must be kept within the limits in Category II.
If the digital display is used to monitor machines
or processes in which, in case of a failure of the
device or an error made by the operator, there
might be risks of damaging the machine or caus-
ing accidents to the operators, it is your respon-
sibility to take appropriate safety measures.
MN05401012E
1.4 Description
The Electronic Display Counter is a multipurpose
device. Depending on the programmed basic
function, the device operates like
• a pulse counter or
• a frequency meter or
• a time meter
2. Setting of the operating pa ra me ters
a. Press both front keys and switch on the supply
b. The display shows
c. After releasing the keys, the display shows
c1.Hold the left key pressed and press the right
c2. Press the right key to switch to
www.comoso.com
voltage or, if the supply voltage is already on,
press both keys simultaneously for 5 s.
key to exit the programming operation.
.
1