Intenso TX500 Bedienungsanleitung Seite 10

USE
System requirements
This external SSD is compatible with the operating systems MS Windows 8 or later and Mac OS 10.x or later.
*Trademarks: Windows 8 is registered trademark of Microsoft Corporation. Macintosh and MAC are regis-
tered trademarks of Apple Computer. All brands and third party names are the property of the respective
user.
Notes:
For the operation of the USB 3.2 Gen. 2x1 an USB 3.2 Gen. 2x1 interface is needed. The external SSD offers
a downward compatibility with previous USB standards.
The hardware configuration of your PC and the used operating system can influence the compatibility of
the external SSD.
Connecting the external SSD
USB 3.2 USB-C
USB 3.2
To connect the external SSD to your computer, please only use the supplied USB cable. Connect the USB 3.2
connector to the Intenso SSD and the USB 3.2 connector of the other cable end to your computer.
The computer recognizes the "new hardware" and installs the driver automatically. Wait until the driver
installation is completed. In the "workplace" there is now another drive with the designation "Intenso"
available.
As soon as the external SSD is connected with the computer, the LED lights up. The LED flashes when a write
or read operation is carried out.
Removing the external SSD
Depending on the used operating system, the external SSD must be logged off before the connection to
the computer is interrupted. For further details please refer to the Help Section of your operating system
provider. The device may not be removed when it is still being accessed (flashing LED). This can lead to
damages and/or data loss. Please close all the files located on the external SSD (photos, documents, etc.)
before removing the external SSD.
EN - Page 3 of 5