Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

level indicator. Risk of burning and electrical shock caused by overflowing water.
Hot coffee could run out the jug when filling too much water. Do not carry or move
the appliance while hot!
Caution: Never use the appliance near hot surfaces and keep the cord away from heat
resources to avoid damage.
Place the appliance on a dry, stable and flat working place next to a power socket.
Run the cable in a way that nobody can pull on it or stumble over it.
See the description on page 2 first to get familiar with the appliance.
Before making coffee for the first time it is advisable to let the water run through 2 - 3 times without
using coffee. Then clean filter and jug. The special smell from new appliances and production
residues will be removed then.
P
r
e
p
a
r
i
n
g
c
o
f
f
e
e
P
r
e
p
a
r
i
n
g
c
o
f
f
e
e
Before switching on the appliance, open the lid and pour the desired volume of water
into the water tank. Always take fresh, cold water never use hot water to fill the tank.
The number of cups can be read on the left side of the tank on the water level indicator.
Do only fill water to the MAX level indicator, not more.
Place the glass jug under the filter arrangement with fully and firmly closed lid. For
maximum heat retention, rinse the glass jug with hot water. The glass jug has a drip-
through-lid. Close the lid firmly, the handle of the glass jug and the lever of the lid must be
parallel. Always place the glass jug on the appliance under the filter unit before you switch
on the appliance!
Open the lid of the filter unit. Insert the permanent filter (paper filter 1 x4 is also possible)
and fill in the desired quantity of ground coffee. Close the lid.
Now the appliance is ready to switch on. Push the frontal switch (Position "I", the switch
is illuminated). The water will be heated and the brewing progress starts. The coffee runs
slowly through filter and drip-through-lid into the glass jug. The filter unit is equipped with
a drip-stop function. Only if the glass jug closed with the drip-through-lid is placed exactly
under the filter holder, the drip-stop function is cancelled and coffee will run exactly.
Do only use the provided glass jug with this appliance. Otherwise exact function is not
assured. Never run the appliance without the provided glass jug with closed lid!
You also can switch manually into "0" position, to interrupt the brewing process.
Remove the glass jug.
For pouring coffee, slightly push the lever (button) at the lid of the glass jug.
The rest of the coffee keeps warm in the glass jug on the keep warm plate.
Switch off after the end of the brewing process ends also the heating of the warming plate.
Rest heat of the warming plate will warm the bottom of the glass jug for a while.
Note:
Fill cold water into the water compartment only. Do not pour milk or ready-made beverages
into the water compartment to avoid staining and damage.
Switch off the appliance and let it cool down for minimum 5 minutes before reusing.
Do not fill water into the coffee maker when it is still hot as it could be dangerous or cause
damage.
Do not forget to switch off the coffee maker when the glass jug is empty and after each use!
Otherwise it will heat all the time. For safety reasons, always unplug after use.
10

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Kf 1730

Inhaltsverzeichnis