Hartan Topline 2.0 GTS Bedienungsanleitung Seite 11

WARNING!
When opening out and folding down the frame and when adjusting the back-rest, pinch-
points may be caused in which fingers etc. can be trapped unless care is exercised. Ensure that your
child has plenty of clearance space.
Unfolding the pram
By pushing the lock buttons 4, unfold the upper section to bring the handle in horizontal position. Pull
handle 1 upwards until handle catch 2 has engag ed.
all catches are locked.
Folding the pram
Important: Swing the handlebar 1 that the white symbols on the twist grip 3 are visible from above. Turn
rotating lock 3 inwards until the handle unlocks, then push the handle down. Then press retaining buttons
4 and fold the top part of the handle downwards.
Reversible handlebar
To reverse the handlebar, turn the twist grips 3a in the direction of the arrow.
reversing the handlebar, take care that no movable parts jam the baby's limbs, or fingers, etc. Finally,
make sure the hand lebar has reengaged properly, which is indicated by a click sound.
Height adjustment of handlebar
Press the two handle-folding lock buttons 4 to bring the upper
section of the handlebar 1 in the desired position.
Sun hood
The sun visor 20 can be folded out and in as additional protection. It can be detached by means of a zip.
Parking brake
To lock the wheels, depress the securing button on the brake lever 7 and
swing the lever down. The two toothed brake-crown wheels engage, which
is indicated by a click sound. To release the brake, swing the lever up until
it snaps into place. Having parked the pram, try to push it to check the
brake.
WARNING!
Make sure the brake is always closed when placing
the baby in the carriage or taking it out of it.
Adjusting the parking brake
After prolonged use, the wheels may cause a rattling noise. You can elimi-
nate the problem by readjusting the setting screw 7a situated at the brake
housing.
Adjust the handbrake (optional)
Readjust the hand brake by means of the cable adjusting barrel 9 (above).
A different brake effect on the two rear wheels can be
corrected by means of the cable adjusting barrel 9a (below).
Adjustable suspension system
By turning the selector 8, a „hard" or „soft" position can be selected for
suspension.
Hood and safety bar
By pressing the bayonet joint 12, the hood or the safety bar can be
pulled out. When inserting it, make sure the safety bar locks into place
correctly and be careful not to pinch any of the fabric parts. By pressing the
buttons, the safety bar position can be changed.
WARNING!
The hood bar of the stroller and the safety bar are
not suitable for carrying the pram.
WARNING!
Before using the pram, make sure
WARNING!
Instructions
When
7
7a
9
8
9a
9