Raddy VP7 Benutzerhandbuch Seite 17

Mounting Instructions (wireless sensor)
Multi-combination Wireless Remote Sensor
Mount in an open area clear for 15 meters (50 feet) in all
directions.
The sensor needs to be mounted on a sturdy platform
or bracket that is mounted 1.5 m (5 ft) above the ground.
The base of the sensor is screwed to the platform and the
support frame. Tighten the large nut that secures the
support rod to the base.
When installing, adjust the sensor body so that the solar
panel faces south, otherwise the wind direction will be
wrong. Note the "N" North Embossed Mark on the top of
the sensor (requires a compass for proofreading, and the
"N" North Emboss mark is identical to the "N" of the
compass).
When installing the sensor, use the top bubble level to
ensure the sensor level, otherwise the accuracy of the
rainfall reading will be affected。
After completing the above two steps, lock the two hexagon
socket screws on the side of the sensor body.
When installing, the fixing screws of the wind cup and the
wind direction cursor should be tightenedand tightened.
The rainforest structure of the sensor needs to be cleaned
regularly (recommended cycle 1-3 months, depending on
the frequency of rain):
1. Remove the rainwater funnel (turn the rain sand funnel
according to the direction of rotation shown).
2. Gently remove debris or insects from the rainsensor.
3. Remove debris from the rainwater funne itself, especially
debris from the funnel drain.
4. Remove the debris from the drain.
5. Reinstall the rainwater bucket.
6. Note: Do not apply oil to the rain sensor.
Note: Make sure the wireless sensor is installed within 100
meters of the weather station (empty, unobstructed).
According to the thickness of the obstacle between
the wireless sensor and the weather station, the
distance should be shortened as much as possible
(the distance after the wireless signal penetrates
the obstacle will be shortened), otherwise the
data transmission may be disturbed.
16
VP7 Weather Station