Raddy VP7 Benutzerhandbuch Seite 14

The weather station automatically searches for all wireless sensors within 3 minutes of power-on and registers the sensor lDs.
Each sensor generates a random ID after power-on to distinguish the sensors.
ln the main display interface, press and release the "CH" button to view the value of the wireless sensor on the different channels.
Note: In view mode, the ID of the wireless sensor can be displayed.
The temperature/humidity data of the additional channel wireless sensor needs to be displayed on the normal time display
interface. After selecting the channel in the viewing mode. touch the "
Note: The temperature and humidity values shown in the OUTDOOR REMOTE column after exit are the select edchannels.
At the same time, in the channel icon (displaying the position of A15), the number of channels isdisplaved:
OUTDOOR (representing Multi-combination wireless sensor) | 1 or 2 or 3 (representing 3channels of temperature |
humidity wireless sensor)
Note: When the weather station loses sensor signals or the sensor is not connected to the channel, the value of the channel
is displaved as " -- "
lf you need to add a new sensor or replace the sensor. ln channel view mode. press and hold the "
seconds, the weather station will search for the 3 minute signal again, and the new channel sensor will be added to the weather
station within 3 minutes.
Note: When adding a new sensor or replacing a sensor (old sensor replacement battery), you need to turn on the sensor power
first, then follow the steps above to control the weather station.
Note: When the channel icon (the position of the display A15) displays the low voltage icon "
corresponding channel wireless sensor is replaced according to the channel number of the channel icon. Then follow the
steps above to re-add the wireless sensor to the weather station.
ln the normal time display interface, press and hold the "CH" button for 3 seconds. the wireless channel in the OUTDOOR REMOTO
column will enter the loop mode, and the channel will be changed every 5 seconds (OUTDOOR | CH1 | CH2 | CH3), and the
automatic conversion display wil be diferent. Channel temperature | humidity value
Note: In the cycle mode, only the values of temperature and humidity are being converted, and the values of wind speed, wind
direction, rainfal, etc. are not converted, and the values are still derived from the Multi-combination wireless sensor.
Weather alerts viewing and setting
Press and release the " " button to view the weather alerts mode. Continue to press and release the "
and move to the next item.
Note: After 20 seconds without pressing any button or touch the "
Note: View Outdoor | REMOTE Temperature | Humidity alert, press and release the "CH" button to switch to other channels.
(A total of 4 channels: outdoor | CH1 | CH2 | CH3)
ln each weather alert view item, press and hold the "
Note: The weather alert is initially turned off by default, and the display is OFF.
When the weather alert is turned on, it is displayed as ON.
Press and hold the " " button for 3 seconds to enter the weather alert setting mode.
Press and release the " " or "
Press and release the " " button to confirm and move to the next item.
Note: After 20 seconds without pressing any button or touch the "
Note: Set Outdoor | REMOTE Temperature | Humidity alert, press and release the "CH" button to switch to other channels.
(A total of 4 channels: outdoor | CH1 | CH2 | CH3)
" button to turn the alert on or off.
" button to adiust the value. Hold the "
13
" location button to exit the viewing mode.
" location button at any time to exit the view mode.
" or " " button to adjust quickly.
" location button at any time to exit the settings.
VP7 Weather Station
" button for more than 3
", the battery of the
" button to confirm