cecotec READYWARM 2070 MAX CERAMIC ROTATE SMART Bedienungsanleitung Seite 35

within a range of 1 to 24 hours.
- Once the timer value has been set, the display will flash for 5 seconds. After this time, the
current temperature value will be displayed, and an "H" icon will be shown.
- Once the set time is reached, the device will stop working.
- To cancel the timer, press the timer setting icon until it reaches 0. The "H" icon will disappear.
6. Press the lock icon for 3 seconds to activate the security lock. Once activated, a padlock icon
will be displayed on the display and the device will not respond when icons are pressed.
To deactivate the lock mode, press the icon again for 3 seconds.
Other functions
Memory
Each time the appliance is switched on, it will remember the last setting chosen.
Standby
When there is no interaction with the device for more than 30 seconds the brightness of the
display will decrease by 50%. After 180 seconds, the display will turn off.
Anti-tilt protection
In the event of the device tilting over, it will automatically turn off. Place it on a flat stable
surface and then turn it on again.
Replacing batteries
Fig. 5
The remote control requires a lithium button battery (CR2025/2032). If the remote control
does not respond, replace the battery as follows:
1. Put the remote-control upside down and slide tab A to the right.
2. Pull out the battery compartment B.
3. Insert a battery of the same type and make sure the positive side is at the top.
4. CLEANING AND MAINTENANCE
Caution: turn off the appliance and unplug it from the mains before cleaning or performing any
maintenance.
Cleaning the surface
- Clean the appliance with a soft, dampened cloth.
- Do not use chemical solvents (such as benzene, alcohol, or petrol) as they may cause
irreversible damage. Make sure that no water enters the control panel or holes in the
structure.
- Do not operate the appliance until it is completely dry.
READYWARM 2070 MAX CERAMIC ROTATE SMART
ENGLISH
35