PLYMOVENT Multidust bank MDB-6-W2 Betriebsanleitung Seite 17

• When mounted all the "towers", install the 9 pins
on the side of each module on one "tower".
• Seal all the frames as shown earlier.
• Join the filter "towers" together
• Tighten the nuts on the inside.
• Fit the spark protection plates to the filter module where
the inlets will be mounted.
Note! The spark plates are not centred; check if the plates
follow the hole radius for the cartridges.
0000100513/011212/0 MDB
16
0