Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.0 Maintenance
4.1 Changing the blade
Disconnect the power supply before changing the blade. Use
work gloves for your own safety.
put on the blade protection
(enclosed in the tools set)
clean and loosen the screws of the
blade mounting.
Set the wrench at a position opposite to
the blade to avoid injury.
attach or change the blade.
Make sure that the blade fits in exactly into the support. On nor-
mal and hard subfloors the bevel of the blade should show
upwards (1), on soft subfloors (e.g. chipboards) the bevel should
show downwards (2).
5.0 Use
5.1 Starting
Mount the long internal tube with 2 screws (A) to the handle
support (Pic. 1).
Telescope the outer tube over it. The length of the handle
may be adjusted by sliding the outer tube and locked with
screw (D).
Place the handle into the end of the tube and latch the
locking (C).
For your safety the DURO-STRIPPER comes with the blade not
mounted.
Installation of the blade, see cape. 4.1.
Fix the mains cable at the handle in order to keep it free from the
blade and the wheels. (S. 23, Pos. 122)
DURO-STRIPPER, Artikel-Nr. 013347
09/2004
Very sharp blade! You may cause injury without using
the blade protection!
A
B
1
Pic. 3
D
C
Pic. 1
Pic. 2
2
11
Werbung
