Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
NOTICE: DO NOT short-circuit the three wires.
NOTICE: comply with cable specifications and
follow the vehicle manufacturer's instructions.
NOTICE: make sure the fuses are easy to
access and replaceable.
NOTICE: DO NOT connect the unit to the
electronic control units (ECU).
Check the connections
26
1. When the panel is turned off, insert the connector
inside the socket until you hear a click sound.
2. Turn on the panel: the page with the data appears on
the display and the LED turns red or green.
3. Turn off the panel: if there is no vibration and no key
is pressed, the unit goes into stand-by mode after
about one minute.
4. Check the wiring if the unit does not turn off after a
few minutes or the Power cable unplugged
message appears on the screen.
5. Turn on the instrument panel again and make sure
the unit turns on and the LED turns red or green.
For further information on LEDs, screen and any
displayed message, see the enclosed Operating
instruction.
Check installation
To verify that the installation was successful, access to
the selftest.telepasskmaster.com portal.
Contact your local dealer to request login credentials.
Set up the unit
Before using the e-toll unit, it must be set up and the
number of axles and vehicle weight must be set. Refer
to the enclosed Operating instruction.
Telepass SAT | Installation Instruction v. 2.2 OCT 2018 | © 2016-2018 Autostrade Tech
Werbung
