Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Clean the application area on
the windshield carefully,
using a multipurpose
detergent.
3. Remove the protective film
from the sticker.
4. Place the unit horizontally on
the clean windshield.
5. Check for air bubbles in the
adhesive area. Press the unit
firmly against the windshield.
Telepass SAT | Installation Instruction v. 2.2 OCT 2018 | © 2016-2018 Autostrade Tech
Connect the unit to the electrical system
1. Cut the cigarette lighter, if
any.
2. Connect the three wires according to the following
diagram.
EN
NOTICE : only use the
supplied cable. DO NOT
use third-party cables or
adapters.
25
Werbung
