Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
NOTICE: make sure the unit does not impede
vision when driving and is outside of reach by
moving parts and airbags.
Installation warnings
CAUTION! Electricity. Short circuit, fire,
damage to the unit and the vehicle. Protect
power cables against external agents (e.g. heat,
chemicals) that may damage the external
insulation coating. Pass cables away from high
temperature zones and use non-conducive
gaskets.
NOTICE: fixed unit installation can only be
performed at authorized workshops by suitably
qualified personnel.
NOTICE: comply with power cable
specifications, unit power limits and follow the
vehicle manufacturer's instructions.
NOTICE: to ensure Velcro strip hold, install the
unit when the environmental temperature is
between 20 °C and 40 °C.
24
NOTICE: before installing the unit, check that all
data included in the vehicle declaration are
correct. Otherwise, ask the vehicle's owner for
an updated declaration.
NOTICE: make sure unit installation does not
inhibit the correct operations of the vehicle and
electrical devices connected to the electrical
system (e.g. tachographs, etc.)
NOTICE: make sure the power cable is not
subject to mechanical, heat or chemical stress
and does not hinder the driver when driving.
Required material
Two 3 A fuses and relevant fuse boxes.
Place the unit on the windshield
Telepass SAT | Installation Instruction v. 2.2 OCT 2018 | © 2016-2018 Autostrade Tech
1. Adhere the Velcro strips to
the support.
Werbung
