Hama 00053187 Bedienungsanleitung Seite 3

Warning
Do not open the product. Do not continue to operate
the product if it is damaged, which may be indicated by
smoke, odours or loud noises. Contact your dealer or
our service department immediately (see "Service and
Support").
Warning – Volume
Always keep the volume at a reasonable level. Loud
volumes, even over short periods, can cause hearing loss.
Warning
Do not connect headphones to the audio output. The
product is not intended for use with headphones.
4. System Requirements
The Hama Bluetooth Audio Receiver supports the
following operating systems:
• Windows XP/ Vista / 7 / 8 / 8.1 / 10
• Linux Kernel 2.6 or later
• Mac OS 10.5 or later
• All other operating systems with Bluetooth A2DP &
AVRCP profile support
• Devices with NFC (near field communication) capability
• The terminal device you wish to play from (mobile
phone, notebook, tablet, etc.) must support the
following Bluetooth profile: Bluetooth version 4.0 (or
higher) + EDR standard.
• Both the source and the receiver must have the same
level of technology for aptX to be used.
5. Getting Started
5.1. Power supply
Warning
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Remove the batteries from products that are not
being used for an extended period (unless these are
being kept ready for an emergency).
• Use an AAA battery.
• Insert the battery into the appropriate battery
compartment on the back. Pay attention to the polarity
in the battery compartment.
• Alternatively, you can connect the included USB power
cable to the power connection (2) on the Bluetooth
adapter and a USB power supply unit with a voltage of
5 V.
Note
• Make sure that you only use either a battery or a USB
power supply unit as a power supply. Never use both
power sources at the same time.
• If you use a rechargeable AAA battery as a power
supply, it will not be charged in the product.
5.2. For use of a smartphone or tablet PC as a
playback source
5.2.1. Bluetooth connection
• Connect the audio output (1) of the Bluetooth Audio
Receiver to the audio input of your hi-fi system using the
included 3.5 mm stereo audio cable.
• Press the on/off switch (3) to switch on the Receiver The
green status LED (5) lights up for 1 second.
• Switch your smartphone or tablet PC on and activate the
Bluetooth function.
• Connect the Bluetooth Audio Receiver to a speaker with
its own power supply or to an AV receiver, etc. using the
included 3.5 mm stereo cable.
• Press the on/off switch (3) on the Receiver for 3-4
seconds to activate the Bluetooth pairing mode. The
orange status LED (5) flashes.
• Also activate the pairing mode on your smartphone or
tablet PC and follow the instructions. (The operating
instructions for your device will also include information
on pairing.)
• The green status LED (5) will light up briefly when the
Bluetooth pairing has been completed successfully.
Note
Some terminal devices require a password in order to
connect to another Bluetooth device.
• If your terminal device requests a password for
connection with the product, enter 0000.
3