RENPHO RF-FM059R-H Bedienungsanleitung Seite 10

Troubleshooting
The 1.Disconnected power or loose
product plug causing poor contact.
does
2.The power switch is off or
not work the timer has been r eset.
3.The motor auto shut s -off
due to the device being on
too long activating overheating
protection.
The
1.Your foot is positioned at
massage
the wrong angle.
intensity 2.Didn't choose intensity
is too high
lev
or too low
No heating 1.The heat function isn't
or
insufficient
2.The working heat mode might
heating be bottom, not full/Instep.
The pr
working p inciple limits how
fast the bottom can heat up.
Therefore, the heating-up
may seem a bit slo w, 7-10
minutes bef ore you can
feel the obvious heat.
The touch
1.The plastic film on the touch
panel is
panel is not r emoved.
not
2.Fingers are wet.
working
3.Insufficient touch ar e a.
properly
1.Re-plug to t h e
power source.
2.T
switch on again.
3.Use the massager
after the motor
cools off naturally.
1.Adjust the contact angle to
get the moderate intensity .
2.The massage has 3 intensity
or you. levels, choose the mode you
prefer. We recommend low
mode to begin wit h.
1.If you press the foot
cover to see the light,
t
e and
2.Choose the Full/Instep
Heat mode to get mor e
sufficient heating.
1.Remove the plastic film
before use.
touching the button.
3.Use your thumb to press
buttons to get better
touch sensitiv ity.
08
he power
. If not, press the
y your fingers bef ore