XZENT 2-DIN Naviceiver X-302BT Bedienungsanleitung Seite 23

SETUP MISC
1
3
4
5
6
7
8
9
10
Operation buttons Setup Misc
1. Source
2. Clock Time
3. Monitor
4. Angle
5. TFT Standby
6. BT mic gain
7. BT name order
8. Tuner Profi le
9. General
10. Safety
11. Display
12. Audio
13. Software
14. Misc
15. Clock
*Note: angle adjustment X-101BT
This setting will defi ne the behaviour of the retractable monitor.
Auto
Show
Manually
*Note: setting the clock
XZENT has an integrated clock that will be automatically synchronized by RDS time signal. Sync is
performed only once on each device start and may require several minutes to show correct real time,
depending on the FM signal quality of the radio station you are listening to. The X-302BT uses a soft-
ware clock which is synchronized by GPS signal. The GPS sync'd time is used for route calculation.
11
Tap to enter Main Menu
Shows Clock time
Tap to change value of monitor (AUTO > SHOW > MANUALLY)*, only
for X-101BT.
Tap to set monitor tilt angle (only for X-101BT)
Tap to start TFT standby function
Tap to change microphone input gain
Tap to change the display sort order of the phonebook
Tap to change tuner mode (stereo > mono)
Tap to enter general mode
Tap to enter safety mode
Tap to enter display mode
Tap to enter audio mode
Tap to enter software mode
Tap to enter misc mode, if not already active
If no other setting is changed (3 ~8) you can tap the clock to set it manually*
Power on
Slide out
Slide out
Stays retracted
2
15
12 13
Power off
Slide in
Stay extended
Slide in
14
23